PCI USB Digital–to-Analog Converter PDAC-U16 

Click here for .pdf file

Features

  • Up to 16 Analog Output Channels
  • Optional 32-Bit Digital Output
  • 50K Samples/Second, Maximum Channel Update Rate
  • Programmable Analog Output Ranges
  • 12-Bit DAC Resolution
  • Operating Systems


Introduction

The PDAC-UXX is a USB device hosted in a PCI form factor. The PCI-USB-based Digital-to-Analog Converter module is a breakthrough in programmable analog output boards used with commercial bus architectures. The PDAC board solves the critical data through-put problem of real-time processing systems in which PCI-based analog output modules are rate-constrained by operating system software such as Windows.

Most modules that need to maintain accurate data-driven, real-time coherency for derived, EU, and raw parameters are limited in two ways: they must use single transfers over the USB bus, and they are limited to the maximum rate handled by operating system timers (approximately 1 kHz for Windows).

Receiving both data and time tags over the USB bus from OMEGA Windows® software, the PDAC board features independent, on-board timers to accurately correlate analog, and discrete outputs at their correct real-time rate. The PDAC module supports raw, EU, derived, and user-defined parameters in a data-driven manner.

As with all boards in our Series-3000 systems, the PDAC module uses plug-n-play technology. It occupies a half-length PCI card slot and may be installed in any compatible factory or customer-provided processing platform.

Input Signals
Input Data USB data, 16-bit words
DAC Input Data Word Format 12 bits data + 4 bits channel address Bipolar:  4095 = full scale +, 2048 = 0V, 0 = full scale –
DAC Input Data Rate 1K – 25K samples/second/channel; data driven tracking
Number of DAC Channels 16 channels standard
Discrete Data 16-bit register
Discrete Output Data Format 16 bits TTL
Discrete Data Rate 25K samples/second/channel maximum
Sinewave Reference Clock Input
Frequency 1 kHz, 10 kHz, 100 kHz, 1 MHz – 50 MHz
Signal Type Single-ended sine wave
Levels 1V – 8V peak-to-peak
DC Offset DC Offset < 10 percent of volts peak-to-peak level centered around ground
Input Impedance 50 ohms, 75 ohms, 10K ohms  (programmable)
SNR  ≥ 50 dB
RS-422/TTL Reference Clock Input
Frequency 1 kHz, 10 kHz, 100 kHz, 1 MHz – 50 MHz
Signal Type RS-422, TTL, LVTTL (3.3V)
Performance
Number of DAC Channels 16 
DAC Resolution 12 bits
DAC Rate 25,000 samples/second(maximum)/channel
DAC Output Voltage Range  +5V to  - 5V
DAC Relative Accuracy ± 2 LSB – (typical) + gain error + bipolar output accuracy
DAC Linearity ± 0.005 percent of FSR (maximum)
DAC Gain Error +/- 0.3 percent (typical)
DAC Bipolar Output Accuracy ± .8 percent of FSR
DAC Bipolar Offset Error ± .2 percent of FSR
Output
DAC Output Current Maximum 0.5 mA/channel – 10 Kohm load
Discrete Output Current Synchronous buffer 1 mA/channel
Data Latency 50 ms < BOARD_LATENCY < 200 ms  (with software suport) +/-15 percent of BOARD_LATENCY data rate tracking
Electrical and Environmental
Form Factor 1/2 size PCI card
Operating Temperature 0° to 50 °C
Operating Humidity 20 to 95 percent noncondensing
Storage Temperature  -20° to 80 °C (storage)
Storage Humidity 20 to 95 percent noncondensing
Power +3.3V from PCI backplane.  Total Power dissipation < 3W.
Status LED indication of Board ID # and operational status
Connectors 44-pin D edge connector for analog outputs and inputs.
40-pin, ribbon cable header for discrete outputs.
Programming Programming via USB bus
Ordering Codes
PDAC-U16 Integrated DAC/Discrete Output, 16 Channels
PDAC-UXX-002 PDAC Option: 16-Channel Digital/Discrete Output

 


All specifications subject to change without notice.  
Revision Date: Aug08
       
Tel 301.737.1555
Fax 301.737.1564